Multi Edit: ARP: Added the Sync To parameter, which allows selecting a specific Riff, Song or Arp to sync to.
Riffs that have Trigger Range and Release Range set to the same key range can now be played with legato fingering, which is useful for Riffs that have Transpose set to On. For example, if you were to hold down the A key to play a Riff, then hold down the B key to transpose the Riff, then release the A key, previously releasing the A key would stop the transposed Riff being played by the B key. Now with these settings a transposed Riff will continue to play until the last key that triggered it is released.
Zone Info: When the Global Mode Show Zone Info parameter is set to Yes, Zone Info in Multi Mode now updates the Zone On indicator when changing Zone Status (Muted/Active) from a pedal assignment.
Zone Info: When the Global Mode Show Zone Info is set to Yes, Zone Info in Multi Mode now properly displays 4 digit Program ID numbers in all cases. Previously, some 4 digit numbers could be cut off.
When recording into Song Mode from Multi Mode, recordings can now be reviewed before saving on the Save New Recording page.
Multi Edit: Overview Page: Fixed a problem with navigation when Exit Values are being displayed on the Overview page.
Multi Edit: Fixed a problem that could cause controls to become unresponsive when changing pages while holding the ENTER button.
Multi Edit: Controls Page: Ribbon: Fixed a problem that was causing the Ribbon Destination parameter to show some invalid destinations.
Multi Edit: Controls Page: Ribbon: When the Ribbon Configuration is set to 3 Sections, the Destination for each section can now be seen in all cases.
Fixed a problem where KB3 Drawbar graphics could be shown for VAST Programs after deleting a KB3 Program.
Program Edit: KB3 Programs: Drawbars Page: When viewing the Drawbars page and moving a slider, the Vol parameter now gets updated in real time.
Program Edit: Fixed a crash that could occur when deleting a Layer used as an Alt Input for another Layer.
Program Edit: The SAVE button LED now lights when a Layer is imported.
Program Edit: FM Layer: Amp Envelope Page: FM Layers are now limited to User Envelope Mode. FM Layers are not compatible with Natural Envelope Mode.
Program Edit: FM Layer: On the FM Operator page, the Break Point parameter can now be set with intuitive entry (hold ENTER then press a key). Previously this would select the wrong key.
Program Edit: FM Layer: On the FM Operator page, fixed a problem where the Left Depth parameter would have no effect if Left Curve was set to -Linear or -Exponential, and Break Point was set to B8 or above.
Fixed a problem that could occur after selecting a Track in Song Mode and exiting to Program Mode, pressing the SAVE button could save the wrong Program.
Fixed problem when Loop is set to On and using the Song Save Changes page, the UI could get stuck in a Save dialog.
Track Page: The Copy function has been renamed to Copy-Paste for clarity.